Gear Selector Lever Quickshift 8200915406 Renault Twingo 2 New Genuine
Regular price:
Regular price:
product unavailable
add to storage
DESCRIPTION
At a glance
| Part | Quickshift gear selector lever — electronic selector |
|---|---|
| Renault number | 8200915406 — 82 00 915 406 |
| Cross reference | 8200521978 |
| Fits | Renault Twingo II 2007-2014 with the Quickshift gearbox |
| Condition | new, genuine Renault |
| Warranty | 12 months |
| Shipping | within 24 h from Bielsko-Biała, VAT invoice |
Before you order — there is a five-minute test
This is the most important paragraph on the page. A Quickshift Twingo that refuses to start often ends up at the garage with a new gearbox robot fitted — when the culprit can be the lever itself, at a fraction of the cost.
The workshop test: unplug the lever's electrical connector and try to start the engine.
| Result | What it means |
|---|---|
| The car starts with the connector unplugged | the lever is at fault — this part solves it |
| The car still will not start | look at the gearbox robot and its actuators, not here |
The second trap: a failed lever usually lights no warning lamp at all. No lamp is not proof that the lever is healthy — and that is exactly why the fault gets hunted everywhere else first.
Will it fit your car
The Quickshift gearbox decides, not the engine and not the year. A Twingo II with the ordinary manual box uses a completely different mechanism — no electronics, and not this number.
| Make | Model | Generation | Gearbox |
|---|---|---|---|
| Renault | Twingo | II, 2007-2014 | Quickshift — automated manual |
How to check: compare the number 8200915406 or 8200521978 with the one on your own lever. If you would rather not strip the centre console, send us your VIN — we check the catalogue and confirm before shipping.
Part numbers
| Number | What it is |
|---|---|
| 8200915406 | Renault catalogue number |
| 82 00 915 406 | same number, factory spacing |
| 8200521978 | cross reference, carried by the same lever |
What this part does
Quickshift is an automated manual gearbox: a robot works the clutch and the gears, and the driver only picks the mode. So the lever is not connected to the gearbox by any cable — it is a purely electronic selector that reads its own position with sensors and reports it to the gearbox control unit.
That is where the common failure comes from. As the sensors or the internal contacts wear, the control unit stops seeing the neutral position — and without a confirmed neutral, the car will not let itself be started. The engine is fine, the starter is fine, and the car sits still.
When it needs replacing
| Symptom | What to look at |
|---|---|
| Car will not start, the starter does not turn | the classic — the control unit cannot see neutral; run the connector test |
| Reverse or neutral will not engage | the position is not being recognised by the control unit |
| Some gears engage, others do not | worn contacts in particular sectors of the lever |
| The fault comes and goes | typical of worn contacts — and the hardest kind to catch |
| No warning lamp despite the symptoms | a failed lever normally lights no lamp |
Fitting, and what comes after
Good news: this lever needs no coding and no programming. After the swap there is nothing to adapt to the control unit — plug the connector in and drive.
Access is from above, through the centre console. While it is apart, look at the condition of the connector and the loom — a chafed wire or green deposit on the pins gives exactly the same symptoms as a worn lever, and a new part will not cure that.
Technical data
| Parameter | Value |
|---|---|
| Part name | Gear selector lever / Quickshift selector |
| Manufacturer | Renault — genuine OE |
| System | automated gearbox control, electronic |
| Gearbox | Quickshift |
| Coding after replacement | not required |
| Condition | new, original packaging |
Condition, shipping and warranty
New part, genuine Renault, in the manufacturer's packaging.
12-month warranty and a VAT invoice with every order. Dispatched within 24 h from our warehouse in Bielsko-Biała, Poland.
Questions we get most often
My Twingo will not start — is it definitely the lever? Do not guess, test it. Unplug the lever's connector and try to start. It starts: it is the lever. It does not: the problem sits in the gearbox robot and a new lever will change nothing.
Does it need coding after fitting? No. This lever needs neither coding nor programming.
Mine is marked 8200521978 — will this one fit? Yes, it is the same item under two numbers.
I have a Twingo II but with the ordinary manual gearbox. Then this part does not fit. The manual box uses a cable mechanism with a different number — write to us and we will give you the right one.
I am not sure about the fit. Send us your VIN — we check the catalogue and confirm before shipping.

All reviews (positive and negative) are displayed. We don't verify that they come from customers who have purchased the product.